Skip to content
Reset StringIO without retaining an old report tail

Reset StringIO without retaining an old report tail

November 19, 2026

Reusing a text buffer for a shorter report can leave part of the previous report at the end. seek(0) moves the cursor but does not clear the contents. Truncate the buffer as part of resetting it.

Set up

Tested on Linux with CPython 3.12.14. Use Bash, Python 3.12 or newer, a text editor, and the mktemp, rm and rmdir utilities. No packages or network access are needed. Keep the same terminal open and stop if setup fails. Run without -O so the assertions remain enabled.

start_dir="$PWD"
work_dir="$(mktemp -d)" || exit 1
cd -- "$work_dir" || exit 1

Run the example

Save as reset_text_buffer.py:

from io import StringIO

with StringIO() as stream:
    stream.write("status=waiting\n")
    stream.seek(0)
    stream.write("ok\n")
    assert stream.getvalue() == "ok\ntus=waiting\n"
    print("After seek and write:", repr(stream.getvalue()))

    stream.truncate()
    assert stream.getvalue() == "ok\n"
    print("After truncate at cursor:", repr(stream.getvalue()))

    for text in ("ready\n", "", "done\n"):
        stream.seek(0)
        stream.truncate(0)
        stream.write(text)
        assert stream.getvalue() == text
        print("Reset and write:", repr(stream.getvalue()))

with StringIO("old") as stream:
    stream.seek(3)
    stream.truncate(0)
    assert stream.tell() == 3
    print("Cursor after truncate alone:", stream.tell())

Run:

python3 -B reset_text_buffer.py

Observed output:

After seek and write: 'ok\ntus=waiting\n'
After truncate at cursor: 'ok\n'
Reset and write: 'ready\n'
Reset and write: ''
Reset and write: 'done\n'
Cursor after truncate alone: 3

Cursor position and buffer length are separate

The short status overwrites only the first three characters. The previous tail remains visible in the complete buffer value. Truncating without a size then cuts the buffer at the current cursor, leaving only the newly written status.

For a full reset before writing, the loop moves to the beginning and truncates to zero. It handles a longer replacement, an empty replacement, and another nonempty value. The assertion after each write checks that no previous text survives.

Truncating alone does not move the cursor. The final check leaves it at position three even though the buffer length is zero. Keep both operations when a reset means an empty buffer ready to write from its beginning. The stream truncation reference and StringIO reference describe these operations.

Choose whether to reuse the stream

A fresh stream for each report can be simpler when callers do not need to keep the same object. Reuse requires callers to agree on ownership of both its cursor and its contents. Another reader of the same stream would observe these changes.

The demonstration keeps all report text in memory and closes each stream with a context manager. Retrieve any needed value before closing. Resetting a stream does not guarantee that its former contents have been securely erased from process memory. These in-memory edits also make no claim about atomic replacement or recovery for disk files.

Clean up

Remove the saved file and empty scratch directory. If the directory is not empty, inspect its contents before removing anything else.

rm -- reset_text_buffer.py
cd -- "$start_dir" || exit 1
rmdir -- "$work_dir"
unset start_dir work_dir

Acknowledgements

This post was created with assistance from AI.

Last updated on