Skip to content
NetScaler CVE-2026-107410: Inventory PUSH load-balancing virtual servers

NetScaler CVE-2026-107410: Inventory PUSH load-balancing virtual servers

November 13, 2026

CVE-2026-107410 is a heap-based buffer overflow in NetScaler Push. Citrix says it can cause unpredictable or erroneous behavior, or denial of service. Bulletin CTX697305, initially published November 12, 2026, assigns a CVSS 4.0 score of 9.3 (Critical).

The vendor precondition is a load-balancing virtual server of type PUSH. Inventory that explicit virtual-server type; an application that sends push notifications does not by itself establish the NetScaler configuration. The bulletin applies to customer-managed appliances and applicable Secure Private Access Hybrid NetScaler instances. Citrix handles updates to Citrix-managed cloud services and Adaptive Authentication.

Select the correct firmware

The bulletin lists these first fixed builds. Earlier builds in each listed branch are affected when the configuration precondition is met:

Product and branchFirst fixed build
ADC and Gateway 14.114.1-73.57
ADC and Gateway 13.113.1-64.39
ADC 14.1-FIPS14.1-73.58 FIPS
ADC 13.1-FIPS and 13.1-NDcPP13.1-37.293

Use the matching build or a later supported release in that branch. Record the edition; standard and FIPS thresholds differ. The bulletin lists supported branches only, so an omitted older release is not evidence of safety.

Inspect a local configuration fixture

In a fresh working directory on Linux, save this synthetic example as synthetic_netscaler_107410.conf. It contains no production data and must not be applied to an appliance. You can remove the fixture when finished.

# Synthetic inventory fixture; do not apply to an appliance.
add lb vserver sample_push PUSH 192.0.2.40 8080
add lb vserver sample_http HTTP 192.0.2.41 8080

Run this read-only check from Bash in the same directory; it requires awk:

awk '
$1 == "add" && $2 == "lb" && $3 == "vserver" &&
$5 == "PUSH" { count++ }
END { print "PUSH LB declarations:", count+0 }
' synthetic_netscaler_107410.conf

Observed on Debian 13 with mawk 1.3.4 on November 13, 2026, exit status 0:

PUSH LB declarations: 1

The HTTP entry uses the same example port but does not match. This is a configuration-text check, not a traffic probe. On an authorized local redacted export, compare matches with the running settings and service ownership. A missing match in an incomplete or differently formatted export cannot establish that a device is unaffected.

Upgrade and verify the service

Follow the vendor’s prerequisites: check platform compatibility and licensing, save and back up the configuration and required custom files, and prepare recovery access. Obtain the matching firmware from NetScaler. In the standalone GUI procedure, use System > System Upgrade, resolve pre-upgrade validation issues and complete the reboot. For an HA pair, upgrade the secondary first, fail over under the documented procedure, then upgrade the original primary.

After reboot, record the running build and edition for every node, including standby members. Check PUSH virtual-server and backend health, then run the application owner’s normal end-to-end delivery check. Review HA state and synchronization. Document failed deliveries or reconnection problems as service-recovery issues; they do not by themselves identify this vulnerability.

The CVE Program API returned HTTP 404 during November 13 checks; the disclosure date and rating here come from Citrix. The bulletin does not establish remote code execution or active exploitation. No appliance or exploit was tested for this article.

Acknowledgements

This post was created with assistance from AI.

Last updated on